全国服务热线 13904127277
公司新闻

圣霖国际联接机价格信赖推荐

发布时间: 2020-07-14 18:15 更新时间: 2020-07-14 18:15






轴毂联接的方式有键联接、花键联接、成形联接、胀套联接、销联接、紧定螺钉联接、过盈联接等,有些联接方式仅用于轴毂联接,有些联接方式可兼作其它联接。键和花键是常见的轴毂联接方式。

The way of shaft hub connection includes key connection, spline connection, forming connection, expansion sleeve connection, pin connection, tight screw connection and interference fit. Some connection ways are only used for hub connection, and some connection ways can be used as other connecti. Key and spline are the most common hub connecti.


一个切向键只能传递一个方向的转矩,传递双向转矩时,须用互成120°~130°角的两个键。用于载荷很大,对中要求不严的场合。由于键槽对轴削弱较大 ,常用于直径大于100mm的轴上。

A tangent key can only transfer the torque of one direction. When the two-way torque is passed, the two keys of 120 to 130 degrees are required. An occasion for heavy load and no strict requirement. As the keyway is greatly weakened to the axis, it is often used on a shaft with a diameter larger than 100mm.


装夹后产品靠近活动钳口附近容易上翘、抬起,多次装夹一致性差。传统机用虎钳的螺旋副间隙较大,在使用中会产生较大振幅的振动;而活动座和虎钳体之间的滑动接触面较大,采用的间隙也较大。



After the clamping, the product is easy to  and lifted near the movable jaw, and the cistency of the clamping is poor many times. The spiral pair clearance of traditional machine vice is bigger, which will cause large amplitude vibration in use. The sliding contact between movable seat and jaw vice body is larger, and the gap used is bigger.


联系方式

  • 地址:辽宁省鞍山市高新区越岭路256号(研发中心A座2号楼510室至511室)
  • 邮编:114011
  • 电话:(0412)
  • 销售:王秋
  • 手机:13904127277
  • 传真:86-412-8259388
  • QQ:1562307997
  • Email:631188434@qq.com
产品分类